TOPBMS High Voltage BMS 12S-240S with active balancing 2A
PC Software ; Please install bms pc software and drive software in the pc before you configurate bms
How to use BMS PC Software ? Please see the below instruction
How to connect bms to pc ?
You need to connect master bms to PC via the adaptor of canbus to USB via CAN 1
The computer needs to select the correct time format(YEAR-MONTH-DAY) as following before you use BMS pc software;
otherwise , The BMS pc sofware can not work well;
Correct Format
Wong Format
and afterwards , you can open the bms pc software as below :
Open Device--->Z CAN USB CAN1---> 500K (Baud Rate)
You can set Port CAN 1 or Port CAN2 for communication port between master bms and PC or between Master BMS and Inverter /PCS
The following Main parameters settings are configurated before BMS leave factory;Please don't change them ;
The other Parametes settings (Cell voltage ,charge current ,discharge current,SOC, temperature)
3-level parameters setting ;
If BMS level 1 and level 2 alarms, the relay will disconnect and then automatically re-close; If level 3 alarms, manual restart of BMS is required.
How to set the battery strings and NTC? Please see " Batter _Configuration"
Real Time Monitoring Of Voltage and Temperature
The charging and discharging quantities should be reset to zero. This needs to be done by filling in "zero" at the initial value section on the home page.
Wiring Diagram for Solar Energy Storage
Wiring scheme for BCU-B3 - ENG-Solar energy storage.pdf
Wiring scheme for slave bms 24S- ENG.pdf
Wiring Diagram for EV
Wiring Scheme for BCU-Q3-ENG-EV.pdf
Wiring scheme for slave bms 24S- ENG.pdf